PVC Christmas Trees🎄 Wanted to line our driveway with something bright and festive, and these PVC trees were the perfect addition! Here’s how we did it: 1. ���Cut (3) pvc pipes into 6ft sections 2. ���Cut (3) scrap pvc into 4 inch sections 3. ���Add 4 screws barely through top of 2 inch end cap + 3 small holes into the sides 4. ���Insert a coupling piece into a 1/2 inch PEX pipe, thread 3 cross connectors, connect ends to create a circle 5. ���Add legs (4inch pvc) into the bottom of each of the cross connectors + drill small hole into the middleng a 2 inch end cap, drill 6. ���Distribute legs into equal thirds, insert long pvc into cross connectors to create tripod + tape in place 7. ���Place end cap on top and drill screws into the side holes + in the middle of cross connectors 8. ���Zip tie end of lights to the base, wrap around a screw at the top, bring back down and zip tie about 2 inches apart from start and repeat around entire tree christmas christmasdecor christmastree christmasdecorating christmasdiy